MuSR Changes¶

Improvements¶

• The updated EstimateMuonAsymmetryFromCounts and CalculateMuonAsymmetry are used in Muon Analysis.
• TF Asymmetry mode now uses CalMuonDetectorPhases and the fitting function is updated to show the normalization.

Bugfixes¶

• Results table can now detect sequential fits.
• Fit options are not disabled after changing tabs.
• The run number is now updated before the periods, preventing irrelevant warnings from being produced.
• In single fit the workspace can be changed.
• In multiple fitting the function can be replaced without causing a crash.
• Loading current run in Muon Analysis and going to previous runs no longer creates an error in the simultaneous fit label.

New¶

• ConvertFitFunctionForMuonTFAsymmetry has been added to help convert fitting functions for TF asymmetry fitting.

Improvements¶

• EstimateMuonAsymmetryFromCounts now updates a normalization table and produces unnormalized data.
• CalculateMuonAsymmetry now updates a normalization table and can take multiple workspaces.

Bugfixes¶

• EstimateMuonAsymmetryFromCounts had a small numerical error in the denominator of the normalisation calculation.
• MuonMaxent and PhaseQuad no longer include dead detectors (zero counts) when calculating the frequency spectrum.
• RemoveExpDecay will not alter data from a dead detectors (zero counts).
• CalMuonDetectorPhases will give an error code for dead detectors (zero counts) in the phase table.
• MuonProcess always crops the data from Xmin.

Release 3.13.0