\(\renewcommand\AA{\unicode{x212B}}\)

MuSR Changes

Muon Analysis 2 and Frequency Domain Analysis

New Features

  • Differences of groups/pairs can be created on the grouping tab.

Improvements

  • Both interfaces are now able to analyse Phasequads.

  • Both interfaces are now able to analyse multiple runs as one run by ticking co-add.

../../_images/MA_co_add.png
  • Input validation has been added to First and Last good Data in the Phase Table tab.

  • When using co-add and creating a phasequad, the deadtime table will now be taken from the first file only.

  • If the start time of a fit is greater than the end time the interface will swap the two.

  • Number of Periods has now been added to the end of Run Information.

  • The tool tip for periods in the grouping table has been updated for more clarification.

Bug fixes

  • A bug has been fixed where ties and constraints were not being respected.

  • A bug has been fixed where editing constraints resulted in a crash.

  • A bug has been fixed where global parameter values would reset when changing the displayed dataset.

  • A bug has been fixed where adding the DynamicKuboToyabe function on the fitting tab of Muon Analysis resulted in a crash.

  • A bug has been fixed where switching to Simultaneous fitting when TF Asymmetry mode is ticked caused an error.

  • A bug has been fixed where switching between the Run and Group/Pair selection when TF Asymmetry mode is ticked caused an error.

  • A bug has been fixed that can sometimes cause the MaxEnt calculation to fail in frequency domain analysis.

  • A bug has been fixed when trying to do a simultaneous fit with no data loaded after pressing clear all would cause a crash.

  • A bug has been fixed where changing rebin wouldn’t update the plot in the GUI.

  • A bug has been fixed where the plot would update incorrectly when changing plot raw and plot difference.

  • A bug has been fixed where pressing autoscale y without any data loaded would cause a crash.

  • A bug has been fixed where autoscale y would not calculate the y limits correctly.

ALC

New Features

  • The data loading section has been updated for this release. See Muon ALC for more.

  • The alpha in the ALC interface can now be set for single period data.

../../_images/ALC_alpha.png

Improvements

  • An x label has been added to the plot in data loading.

  • Imported data will now be loaded into all three pages on the ALC interface.

Bug fixes

  • Stopped scientific notation when plotting run numbers on x axis.

  • A bug has been fixed where exported results were unintentionally being mixed together in their group workspaces.

  • A bug has been fixed where the Load button had to be pressed twice after an initial batch of runs had already been loaded.

  • A bug has been fixed where the log was being reset when loading runs after an initial batch of runs.

  • A bug has been fixed where you could move startx and endx markers past the limits of the data in baseline modelling.

Elemental Analysis

New Features

Bug fixes

  • A bug has been fixed in the Elemental Analysis GUI where minor peaks wouldn’t be added to a new detector subplot.

Algorithms

Fit Functions

  • The conversion factor for field in StandardSC has been fixed.

Release 6.0.0