MuSR Changes#

Interface#

Improvements#

The updated EstimateMuonAsymmetryFromCounts and CalculateMuonAsymmetry are used in Muon Analysis.
TF Asymmetry mode now uses CalMuonDetectorPhases and the fitting function is updated to show the normalization.

Bugfixes#

Results table can now detect sequential fits.
Fit options are not disabled after changing tabs.
The run number is now updated before the periods, preventing irrelevant warnings from being produced.
In single fit the workspace can be changed.
In multiple fitting the function can be replaced without causing a crash.
Loading current run in Muon Analysis and going to previous runs no longer creates an error in the simultaneous fit label.

Algorithms#

New#

ConvertFitFunctionForMuonTFAsymmetry has been added to help convert fitting functions for TF asymmetry fitting.

Improvements#

EstimateMuonAsymmetryFromCounts now updates a normalization table and produces unnormalized data.
CalculateMuonAsymmetry now updates a normalization table and can take multiple workspaces.

Bugfixes#

EstimateMuonAsymmetryFromCounts had a small numerical error in the denominator of the normalisation calculation.
MuonMaxent and PhaseQuad no longer include dead detectors (zero counts) when calculating the frequency spectrum.
RemoveExpDecay will not alter data from a dead detectors (zero counts).
CalMuonDetectorPhases will give an error code for dead detectors (zero counts) in the phase table.
MuonProcess always crops the data from Xmin.